Heron Project setup stuff

I use the same surface for drawing that I do for carving, and I can’t really put a hole through it, so here is my bench dog solution. I opted for holes at the edge where they won’t interfere with the drawing surface. For now, at least, since I don’t think I have to use much force when clearing large areas of waste, this will work.

Here’s the outside kento I built for the heron print. The blocks vary in thickness, so I have to prop some of them up. I used a chunk of yellow pine to make the registration block on the bottom, and boy is it hard!

Heron project 1

Fish again? Sooooo boring….

Blocks

I started working on this print during my recent trip to Japan. I was gifted a few small off-cuts of cherry-surfaced plywood from the folks at Mokuhankan (mokuhankan.com). These were only 2 3/8 inch by 7 inches, so I opted for a vertical design. Since the pieces are so small, I decided I would use the full surface, and would construct an outside kento – basically a jig to hold the blocks that incorporates registration marks. Using the full surface is sort of risky, because if the edge gets damaged, that affects the image, but I felt it was worth the risk since the dimensions were so small.

Here are the blocks as they were before I started much of the test printing.

dark gray, blue, key block
light gray, green and red, yellow