Another block? What’s going on?

Nope, not adding a block to the forest rays print! The truth is, I just don’t have the time to start printing that one. I need several continuous days without many other responsibilities; I think I will need to take vacation to do the printing. Carving, however, is something I can spend a couple of hours on here and there. Plus I really love carving! So, motivated by that excitement and a new design idea, I’ve prepared another block. I’ve used a card scraper to smooth the surface – it yields the same kind of surface that can be achieved with a hand plane, but is a lot less expensive and requires less skill to use.

Since the last design was so complicated, for this one, I am aiming for simple simple simple. All the impressions will fit on ONE piece of wood (with two laminated cherry faces). I’m thinking monochrome too!

I got everything ready before starting the carving. I figured out the final size, cut the paper, and planned out where on the wood each impression will go.

A few of the sheets of washi have some flaws. One has a tiny blood stain because I trimmed off the very tip of my thumb cutting them 😦 and others had some bends in the paper. I’ll print them all – the sheets with slight bends might turn out fine after being dampened and printed. The sheets with (possible) flaws got a little line as a corner mark; the others got a dot on the corner that is the squarest, which will go into the corner kento when it’s time to print. 50 sheets in all! My biggest print run yet.

Now to paste down that hanshita and take a knife to the block!