When I made the plan for how to put the colors on the blocks, it seemed obvious that by rotating one of these 180 degrees, I could fit both of them on the same block:

It turns out it was not that straightforward! When I lined the two transfers up with a light board, to make sure they would both fit on the block without interfering with each other’s registration marks, I ended up with this situation. If I place one of the transfers at the position of the normal corner registration mark (red circle, upper left), the registration corner of the OTHER transfer sheet is hanging out in space (green circle, lower right). So without special provisions, I can’t fit them onto the same piece of cherry.

You can already see the solution (or part of it) in the image above. By gluing the cherry to a larger piece of plywood, and using small pieces of cherry strategically placed, I’m able to move the registration cuts out to locations that will let me place both colors on the same block:

And here are the two transfers, pasted down: