Fish again? Sooooo boring….
I started working on this print during my recent trip to Japan. I was gifted a few small off-cuts of cherry-surfaced plywood from the folks at Mokuhankan (mokuhankan.com). These were only 2 3/8 inch by 7 inches, so I opted for a vertical design. Since the pieces are so small, I decided I would use the full surface, and would construct an outside kento – basically a jig to hold the blocks that incorporates registration marks. Using the full surface is sort of risky, because if the edge gets damaged, that affects the image, but I felt it was worth the risk since the dimensions were so small.
Here are the blocks as they were before I started much of the test printing.